Ŀ
		 ACCTON TECHNOLOGY CORPORATION			
	  ETHERPOCKET PACKET DRIVER INSTALLATION GUIDE		
								
		     09/17/1992 VERSION 2.01			
								
	Copyright 1989-1992 ACCTON Technology Corporation	
		      All rights reserved.			


You have just opened the Packet Driver READ.ME file. It contains
instructions on the  PC/TCP Packet Driver  installation  for the
following EtherPocket lan adapters:

	Ŀ
	   Product Name	    Product Number   
	Ĵ
	  EtherPocket-10T	       EN2201	     
	  EtherPocket-CX	       EN2202	     
	  EtherPocket-Duo	       EN2209	     
	


Installation:

Use  the  ACCTON EtherPocket packet driver with  PC-210.   To
load the packet driver use the following syntax:

PEPKTDRV <packet_int_no>

where:

<packet_int_no>    This specifies the software interrupt vector
		   where  you  will  load  the	packet	driver.
		   It must be in the range 0x60 to 0x80.

		   The	PC/TCP kernel, by default, is  loaded  at
		   interrupt  0x61  (so  don't  load  the  packet
		   driver there!)

Example:

The  following	command  line loads the ACCTON EtherPocket packet
driver at the software interrupt vector 60h:

PEPKTDRV 0x60 (=> automatically detect the printer port. )

Note: The placement of 0x prior to the parameters.

After the packet driver is loaded,  you can run the PC/TCP kernel
ETHDRV.EXE.  The PC is then ready for PC/TCP communications.

		       ---the end---
